Plastic bottle crusher

The plastic bottle crusher is specially designed for the crushing of mineral water bottles, beverage bottles, plastic bottles, and preforms. Because most of the raw materials for beverage bottles and mineral water bottles and preforms are PET, it is easy to generate static electricity after rubbing, so that the crushed bottle The sheet adheres to the cutter and the screen and is not easy to cut. Qinfeng plastic bottle crusher series adopts high-speed steel laminating tool, which utilizes the super hardness of the tool to enhance the cutting function and the screen is hard chrome-plated. At the same time, since the round-shaped hollow bottle is easily pulverized in the pulverization chamber during the pulverization process, it cannot be pulverized. The plastic bottle pulverizer adopts a hollow turret to enable a larger rotating diameter during the rotation of the tool, and tightly hugs the bottle to crush and cut so that the smashing is smoother. Operating procedures

1. Plastic bottle crusher production operation process

1. Look at the rotation direction of the plastic bottle crusher impeller from the feed port. The flywheel impeller should rotate counterclockwise. If it rotates clockwise, check the motor connection line.

2. If equipped with automatic feeding conveyor, when the conveyor stops running, the feeding should be stopped immediately, because the conveyor should be interlocked with the feeding system to open and stop, otherwise it will cause the impeller to be crushed, thus burning the motor or causing equipment. Damage

3. The plastic bottle crusher must be continuous and uniform during the feeding process. Do not feed the material larger than the specified size. When large pieces of material are found, they should be removed in time. Otherwise, the imbalance of the impeller and the excessive wear of the impeller may be caused, or even The crusher is stuck so that the crusher cannot work normally and burn the motor;

4. In the production process of the crusher, there are severe vibrations and abnormal noises. It should be stopped and checked immediately. After the fault is discharged, it can work again in order.

2. Plastic bottle crusher routine maintenance

1. Regularly stop the inspection to check the wear of the internal parts of the crusher. The worn parts should be replaced or repaired in time. After the wear block is worn, it should be replaced at the same time. It is found that the wear of the impeller should be replaced in time or repaired by the manufacturer. To ensure the balance of impeller operation;

2. The crusher uses grease, the amount of addition is 1/2-1/3 of the bearing cavity, the crusher works 300-400 hours to add the appropriate amount of grease, work 2000 hours to open the spindle assembly to clean the bearing, work 7000 hours - 10000 hours, new bearings should be replaced;

3. In the normal working condition of the plastic bottle crusher, it is forbidden to open the observation to avoid dangerous accidents;

4. The driving belt tensioning force should be adjusted to the appropriate size to ensure uniform force on the V-belt so that the equipment can work smoothly and normally;

5. The plastic bottle crusher is high-speed operation equipment. When the crusher is running, special attention should be paid to safety production. The operator should operate in the designated position, and the unrelated personnel should be away from the equipment.