Situation of plastic granulator

Plastic granulators are an important part of the plastic recycling process, and because the needs are for shaping plastics, the mechanical structure is special. If you do not pay attention to the use of mechanical parts, it is easy to cause mechanical damage and production safety accidents.

1, granulator should go forward; avoid reverse.

2. The granulator should not run on an empty stomach on a cold machine. It must be heated and fed to run to avoid sticking (shaft holding).

3. It is strictly forbidden to enter ironware and other debris in the inlet of the granulator and the vent hole. So as not to cause accidents and affect production.

4. Pay attention to the temperature change of the fuselage at any time. When you touch the sliver with clean hands and do not stick to your hands, you should immediately heat up. Until the sliver sticks to the hand is normal.

5. When the bearing part of the reducer burns hands or is accompanied by noise, it should be repaired in time and refueled.

6. When the bearing parts at both ends of the bearing room of the main engine become hot or there is noise, stop the machine for maintenance and fill it with butter. During normal operation, the bearing chamber is filled with butter every 5-6 days.

7. Pay attention to the operation rules of the machine; for example, the machine temperature is high or low, and the speed is fast, you can deal with it in time according to the situation.

8. When the plastic granulator body is unstable, you should pay attention to check whether the gap between the coupling and the coupling is too tight, and loosen it in time.