Shuliy is a well-known enterprise that supplies granule machines. In order to let everyone better understand the knowledge related to granule machine, the following article will explain the common knowledge of granule machine maintenance.
a: The grass powder content of the machine in the production of raw materials shall not exceed 50%.
b: The length of the granules is adjusted by moving the position of the cutter above the discharge port.
c: When replacing the particle machine template, the reverse nut should be removed first. There are two symmetrical 8mm screw holes on both sides of the template center hole. You can use the bolt to slowly push out the template. If you feel strenuous, you can hammer the template with a hammer. Then, tap the bolt and prevent the bolt from being broken in the hole.
d: In the case of normal production, the pressure roller bearing must be cleaned once with gasoline or diesel for five days. At the same time, it needs to be filled with high-speed lubricating oil. The gearbox is usually repaired once every six months. The vertical shaft bearing needs to be cleaned once every 7 days, the spindle part works. Must be buttered for eight hours.
e: Before the granule machine is used, stop feeding before stopping. After the material in the silo is processed, add the oily material into the hole of the template to keep the inside of the hole lubricated, so that the plugging will not occur in the next use.
No comments:
Post a Comment