Utilization of plastic pellet making machine

The plastic pellet making machine is an important part of the plastic recycling process, and because it needs to be shaped for plastic, the mechanical structure is special. If you do not pay attention to the use of mechanical parts, it is easy to cause mechanical damage and production safety accidents.

　　 1. The granulator is going to run forward; avoid reversing.

　　 2. The granulator should not run on an empty stomach. The machine must be heated and fed to run, so as to avoid sticking (shaft holding).

　　 3. It is strictly forbidden to enter iron and other debris in the air inlet of the pelletizer. So as not to cause accidents and affect production.

　　 4. Pay attention to the temperature change of the body at any time. When touching the sliver with clean hands and not sticking your hands, you should immediately heat up. It is normal until the sliver touches the hand.

　　 5. When the bearing parts of the reducer are burnt, or accompanied by noise, they should be repaired in time and refueled.

　　 6. When the bearing parts at both ends of the bearing housing of the main engine are hot or have noise, stop the machine for maintenance and fill with butter. In normal operation, the bearing room is greased every 5-6 days.

　　 7. Pay attention to find out the operation rules of the machine; for example the temperature of the machine is high and low, the speed is fast and slow, and it can be dealt with in time according to the situation.

　　 8. When the body of the plastic pellet making machine is unstable, you should pay attention to check whether the gap between the couplings is too tight, and it should be loosened in time.